What tools are necessary for extraction of a broken charger from an iPhone?

How to Get a Broken Charger Out of an iPhone

It can be frustrating when a charger gets stuck in an iPhone. However, there is a solution that you can try before attempting to take it to an Apple store or phone repair shop.

1. Turn off the iPhone

The first step is to turn off your iPhone. This is important to ensure that you don’t cause any further damage to the device.

2. Inspect the Charger

Take a close look at the charger and assess the situation. If there is any visible damage to the charger, such as a bent or broken tip, then you may want to consider replacing it altogether.

3. Use a Pair of Pliers

Take a pair of pliers and gently apply pressure to the base of the charger. Slowly wiggle the charger back and forth until it starts to loosen. Be careful not to apply too much pressure, as this can cause damage to the phone or the charger.

4. Use a Toothpick

If the pliers don’t work, try using a toothpick. Carefully insert the toothpick into the charging port and gently pry out the broken piece of charger. Again, be careful not to apply too much pressure, as this can damage the charging port.

5. Use Compressed Air

If the toothpick doesn’t work, try using compressed air. Hold the can of compressed air upside down and spray it into the charging port, focusing on the broken piece of charger. This will freeze the piece of charger, making it easier to remove. Then use the toothpick to gently pry it out of the port.

6. Take it to a Professional

If all else fails, take your iPhone to a professional. They will have the necessary tools and expertise to safely remove the broken charger from your device.

Getting a broken charger out of an iPhone can be a frustrating experience, but by following these steps, you can safely and successfully remove it yourself.

Living in this era of constant technological advancement, it is becoming increasingly important to be able to deal with tech-related issues that arise. It’s a common occurrence to have a charger break within the phone itself. Thankfully, the task of getting a broken charger out of an iPhone isn’t overly difficult, but here are a few tips to keep in mind.

First of all, make sure the phone is powered down completely. This is important for safety reasons to avoid a possible electrical shock. Use a plastic tool such as a guitar pick, toothpick, or plastic kitchen utensil to wedge between the rear case and the screen. Take care to gently slide the tool around in order to work in between the case and phone. Once a sufficient opening is made, you should be able to slide the tool around the circumference of the phone in order to pry off the rear casing. Usually, you would be able to use just your hands here, but if the case is too tight, the tool will be necessary in order to provide leverage.

Once the rear casing is safely removed, you will be able to access the broken charger. Using a pair of tweezers, carefully pull out the broken charger. You may find it beneficial to use a magnifying glass to be able to tell the difference between the broken charger and the other parts of the phone. Once the broken part has been successfully removed, you can replace it with a new charger and reassemble the phone.

By taking the time to properly remove the broken charger, you will be able to save yourself from any potential future problems, and the phone will be working as good as new in no time.